In-situ TROLL Net Hub Instruction Sheet Manual de usuario descargar pdf

Instruction Sheet

TROLL

Net Hub

Part number 0092160 (4-port bulkhead) | 0092170 (8-port bulkhead) | 0092180 (4-port strain relief) | 0092190 (8-port strain relief)

TROLLNet Hub Overview

The TROLL Net Hub allows a cabled network of up to

16 instruments connected by up to five TROLL Net

Hubs. Each cable within the network has a maximum

length of 1290 m (4000 ft), per Modbus (RS485)

protocols.

The TROLL Net Hub is available in four models.

l 8-port with bulkhead connectors (and 1 strain

relief )

l 4-port with bulkhead connectors (and 1 strain

relief )

l 8-port with strain relief connectors (9 strain relief

total)

l 4-port with strain relief connectors (5 strain relief

total)

Changing the Device Address

When networking multiple Level TROLL, Aqua TROLL,

Rugged TROLL, or RDO PRO Instruments, each

device requires a unique device address.

Complete the following steps with the instrument

connected to the software.

1. Click the Device Setup tab.

2. Click the Modbus Setup... button.

3. Select the Device Address box and change the

number to the desired value.

4. Click the check mark to save changes. Click Yes

when asked to proceed.

5. Click No when prompted to save the changes as

the new default settings.

You must change Win-Situ Software

communication settings to match the device

address next time you connect the

instrument. See page 4.

Attaching Strain Relief Connectors to

the Enclosure

The number of strain relief connectors attached to the

housing depends on the model. All models have at least

one strain relief to attach (the master port, shown

below)

Information subject to change without notice. In-Situ, In-Situ logo, BaroMerge, BaroTROLL, HERMIT, Pocket-Situ, RDO, RuggedCable,

RuggedReader, TROLL, and Win-Situ are trademarks or registered trademarks of In-Situ Inc.

12/2012 | Rev. 003 | 0092292

1 2 3 4

Instruction Sheet 1

Indice de contenidos

Pagina 1 - Instruction Sheet

Instruction SheetTROLL®Net HubPart number 0092160 (4-port bulkhead) | 0092170 (8-port bulkhead) | 0092180 (4-port strain relief) | 0092190 (8-port str

Pagina 2

Instruction Sheet1. Unscrew the strain relief from the nut and thegrommet as shown below.Make sure that there is an O-ring present on thegrommet.2. Tw

Pagina 3

Instruction SheetNumber Wire Color Function3 Blue RS485 (+)4 Red Power DC+The center screw terminal block is the master, whichconnects to the TROLL®Li

Pagina 4

Instruction Sheetexternal power source. This causes the TROLL NetHub to cease functioning.For bulkhead connector models, disconnect the redPower DC+ w

Comentarios a estos manuales

Sin comentarios

In-situ TROLL Net Hub Instruction Sheet Manual de usuario

Busca en linea o descarga Manual de usuario para Accesorios para el agua In-situ TROLL Net Hub Instruction Sheet. In-Situ TROLL Net Hub Instruction Sheet User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios para el agua In-situ TROLL Net Hub Instruction Sheet